Boundless ADDS 6700 Manual Page 64
- Page / 177
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
1
/
4
-DIN,
1
/
8
-DIN &
1
/
16
- DIN Controllers & Indicators - Product Manual
59305, Issue 7 – March 2014 P6100, P8100 & P4100 Model Group Page 59
Parameter
Modbus
Parameter No.
ASCII Ident &
Message Types
Notes
Secondary
Proportional Band
5
R/W
U
Type 2, 3/4
R/W
Adjustable 0.0% to 999.9% of input
span. Read only when Self-Tuning.
Primary
Proportional Band
6
R/W
P
Type 2, 3/4
R/W
Adjustable 0.0% to 999.9% of input
span. Read only when Self-Tuning.
Direct / Reverse
Acting
7
R/W
1 = Direct Acting, 0 = Reverse
Automatic Reset
Time
(or Loop Alarm
Time)
8
R/W
I
Type 2, 3/4
R/W
Integral Time Constant value.
(or Loop Alarm Time value in ON/OFF
control mode if Loop Alarm Enabled)
Read only if Self-Tuning.
ASCII range: 0 to 99m 59sec (99.59)
Modbus range: 0 to 5999
Rate
9
R/W
D
Type 2, 3/4
R/W
Derivative Time Constant value.
Read only if Self-Tuning.
ASCII range: 0 to 99m 59secs. (99.59)
Modbus range: 0 to 5999
Output 1
Cycle time
10
R/W
N
Type 2
Type 3/4
RO
R/W
0.5, 1, 2, 4, 8, 16, 32, 64,128, 256 or
512 seconds.
Scale Range
Lower Limit
11
R/W
H
Type 2
Type 3/4
RO
R/W
Lower limit of scaled input range
Scale Range
Upper Limit
12
R/W
G
Type 2
Type 3/4
RO
R/W
Upper limit of scaled input range
Alarm 1 Value
13
R/W
C
Type 2, 3/4
R/W
Alarm 1 active at this level
Alarm 2 Value
14
R/W
E
Type 2, 3/4
R/W
Alarm 2 active at this level
Manual Reset
15
R/W
J
Type 2, 3/4
R/W
Bias value. 0% to 100% for single
control output or
-100% to +100% for dual outputs
Overlap /
Deadband
16
R/W
K
Type 2, 3/4
R/W
20% to +20% of + ;
Negative value = Deadband
Positive value = Overlap
On / Off Differential
17
R/W
F
Type 2, 3/4
R/W
0.1% to 10.0% of input span
Used for Primary output on/off
differential and for combined Primary
and Secondary on/off differential.
Decimal Point
Position
18
R/W
Q
Type 2
Type 3/4
RO
R/W
0 = xxxx
1 = xxx.x
2 = xx.xx
3 = x.xxx
Read only if not Linear Input.
Output 2
Cycle Time.
19
R/W
O
Type 2
Type 3/4
RO
R/W
0.5, 1, 2, 4, 8, 16, 32, 64,128, 256 or
512 seconds.
- Warranty 5
- Limitations 5
- Contents Page Number: 6
- How to use this manual 14
- 1 Introduction 15
- 2 Installation 16
- 3 Plug-in Options 19
- 4 Wiring Instructions 25
- Use of Shielded Cable 26
- Noise Suppression at Source 26
- Connections and Wiring 28
- 5 Powering Up 40
- Displays 41
- LED Functions 41
- Select Mode 43
- Automatic Tune Mode 44
- Product Information Mode 45
- Lock Code View 47
- RSP value. Constrained 54
- Navigating in Operator Mode 59
- Manual Control Mode 62
- + ; 64
- by Scale Range 65
- Valve Position Clamping 78
- Parameter 86
- Parameter No 86
- Changing Parameter Values 103
- Entry into the Setup Mode 110
- Entry into Operator Mode 114
- Din Indicator Units Display 116
- Alarm Indications 116
- Multi-Point Scaling 117
- Tare Feature 117
- Bit Parameters 118
- Word Parameters 119
- Manually Fine Tuning 125
- Physical Layer 126
- Link Layer 127
- Device Addressing 128
- Supported Modbus Functions 128
- Function Descriptions 128
- Exception Responses 131
- 14 ASCII Communications 132
- Type 1 Message 133
- Type 2 Message 134
- Type 3 Message 134
- Error Response 135
- 15 Calibration Mode 136
- Recalibration Procedure 137
- 16 Appendix 1 – Glossary 138
- Type: General Parameter 139
- Figure 42. Alarm Operation 140
- , default value = 25% 142
- , Default value = 5 144
- . Default value = 5 144
- parameter 145
- ,default value = 147
- , default setting = .. 150
- to in 150
- , default setting = 150
- Type: Controller Parameter 151
- Type: Controller Definition 152
- Type: General Definition 153
- Type: General Parameter 155
- . It is 158
- , default value = 5.0% 158
- Universal Input 165
- DC Linear 167
- Auxiliary Inputs 168
- Digital Inputs 168
- Output Specifications 169
- Control Specifications 171
- Process Alarms 171
- Digital Communications 171
- Reference Conditions 172
- Operating Conditions 172
- Standards 172
- Physical Specifications 173
- Model Type 174
- Input Type 174
- Option Slot 1 174
- Option Slot 2 174
- Packing Options 176
- Special Variants 176
© 2020, manymanuals.com. All rights reserved. | 2.050 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals