Boundless ADDS 6700 Manual download pdf (Page 116)

-DIN,

-DIN &

- DIN Controllers & Indicators - Product Manual

59305, Issue 7 – March 2014 P6010 & P8010 Model Group Page 111

Din Indicator Units Display

The P8010

Din indicators have an additional Units Display. In Operator Mode, this display

shows

 or

 when a temperature input range is displayed, and is blank for linear inputs.

The units display is also used in other modes as a confirmation of the parameter type

currently shown in the main display. This display is not fitted on P6010

Din indicators.

Alarm Indications

The alarm status screen indicates any active alarms, in addition the associated

Alarm LED flashes.

For latching alarm outputs, the LED FLASHES when the alarm condition exists,

and goes to ON when the alarm condition is no longer present if the output has not

yet been reset, to indicate that the relay is in the Latched on condition.

Resetting Latched Alarm Outputs

Latched outputs can be reset whilst the Process variable or Alarm Status screens are

displayed, via the Digital Input (if fitted), with a communications command via the RS485

module (if fitted) or from the front keypad as follows:

Press either or to reset the latched relay(s).

Note:

Outputs will only reset if their alarm condition is no longer present.

CAUTION:

A reset will affect ALL latched outputs.

Resetting Alarm 1 Active Time, Minimum PV or Maximum PV

The stored Maximum PV value, Minimum PV value or Alarm 1 active Elapsed Time value can

be reset via the Digital Input (if fitted), with a communications command via the

RS485 module (if fitted) or from the front keypad as follows:

Press to select the parameter to be reset.

Press either or for three seconds.

The display briefly shows  when the value is reset before the unit reverts to the

requested display.

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 176 177

No comments

Boundless ADDS 6700 Manual Page 116